Removal Procedure

2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Removal Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2007 GMC Savana Special, 2007 GMC Savana Camper Special, 2007 GMC Savana, 2007 Chevrolet RV Cutaway, and 2007 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the radio and mounting bracket. Refer to Radio ReplacementΒ .
  2. Remove the engine cover. Refer to Engine Cover Replacement .
  3. Disconnect the antenna cable connector at the lower right of the instrument panel.
  4. Fig 1: Antenna Cable & Retaining Clips On Instrument Panel Carrier
    GM331979Courtesy of GENERAL MOTORS CORP.
  5. Remove the antenna cable (1) from the retaining clips on the instrument panel carrier.
  6. Fig 2: Antenna Cable At Vehicle
    GM331984Courtesy of GENERAL MOTORS CORP.
  7. Remove the antenna cable (1) from the vehicle.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.