SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 9 (ENGINE CONTROLS - SERVICE & ADJUSTMENT SPECIFICATIONS)QUICK-SERVICESERVICE INTERVALS & SPECIFICATIONSREPLACEMENT INTERVALS (ALERO & GRAND AM)
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2

Replacement Intervals (Alero & Grand Am)

2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Replacement Intervals (Alero & Grand Am)
WARNING: This page is about a different car, the 2003 Pontiac Grand Am, 2003 Oldsmobile Alero, and 2003 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
REPLACEMENT INTERVALS (ALERO & GRAND AM)

Component Miles
Air Filter (1)
Accessory Drive Belt (2)
Automatic Transaxle Fluid (3)
Engine Coolant (4) 100,000
Fuel Filter (5)
Manual Transmission/Transaxle Fluid (5)
Oil & Filter (6)
Spark Plugs 100,000
Timing Belt (7) N/A
(1) Inspect the air cleaner/filter every 15,000 miles and replace every 30,000 miles
(2) Check and replace as necessary.
(3) Under normal service conditions, periodic replacement is not required. If used under severe service conditions, replace every 50,000 miles.
(4) Use only DEX-COOL® coolant or equivalent silicate-free coolant.
(5) Periodic replacement is not required.
(6) Replace every 3000 miles, or every 3 months, whichever occurs first
(7) Engines are not equipped with a timing belt.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.