SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 897 (LIGHTING SYSTEMS)COMPONENT LOCATORLIGHTING SYSTEMS CONNECTORSTURN SIGNAL/HAZARD FLASHER MODULE
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2

Turn Signal/Hazard Flasher Module

2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Turn Signal/Hazard Flasher Module
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2007 GMC Savana Special, 2007 GMC Savana Camper Special, 2007 GMC Savana, 2007 Chevrolet RV Cutaway, and 2007 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Turn Signal/Hazard Flasher Module Connector End View
GM800518Courtesy of GENERAL MOTORS CORP.
Turn Signal/Hazard Flasher Module Connector & Terminal Parts Information

Connector Part Information 
  • OEM: 15332177
  • Service: 15332177
  • Description: 16-Way F GT 150 Series (BK)
Terminal Part Information 
  • Terminal/Tray: 12191812/19
  • Core/Insulation Crimp: Pins A, B, D-F, J - C/A
  • Core/Insulation Crimp: Pins C, G, H, K-N - E/C
  • Release Tool/Test Probe: 15315247/J-35616-2A (GY)
Turn Signal/Hazard Flasher Module Terminal Identification

Pin Wire Color Circuit No. Function
A D-BU 5364 Left DRL/Turn Supply Voltage
B YE 18 Left Rear Stop/Turn Lamp Supply Voltage
C L-GN/BK 592 DRL Low Control
D D-GN 19 Right Rear Stop/Turn Lamp Supply Voltage
E D-GN 5365 Right DRL/Turn Supply Voltage
F WH 17 Stop Lamp Switch Signal
G L-BU/WH 1314 Left Front Turn Signal Lamp Supply Voltage
H D-BU/WH 1315 Right Front Turn Signal Lamp Supply Voltage
J RD/WH 540 Battery Positive Voltage
K WH 111 Hazard Switch Signal
L L-BU/WH 1414 Left Turn Signal Switch Signal
M D-BU/WH 1415 Right Turn Signal Switch Signal
N BK 350 Ground
P-S - - Not Used
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.