Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 806 (POWER DOOR LOCK SYSTEM AND RELEASE SYSTEMS)DIAGNOSTIC INFORMATION AND PROCEDURESPOWER DOOR LOCKS INOPERATIVECIRCUIT/SYSTEM VERIFICATION
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2
Circuit/System Verification
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Circuit/System Verification
WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition ON, observe the scan tool Lock Switch and Unlock Switch parameters while pressing both the door lock and door unlock switches. The reading should change between ON and OFF.
- If the reading does not change, refer to Door Lock Switch Malfunction. under Circuit/System Testing
- Command the Driver Door Unlock ON and OFF with a scan tool. The driver door should unlock.
- If the driver door does not unlock, refer to Driver Door Unlock Relay Malfunction under Circuit/System Testing .
- Command the Passenger Door Unlock ON and OFF with a scan tool. All of the passenger doors should unlock.
- If one or more passenger door do not unlock, refer to Passenger Door Unlock Relay Malfunction under Circuit/System Testing .
- Press the door lock switch. All of the vehicle doors should lock.
- If one or more vehicle doors do not lock, refer to Door Lock Relay Malfunction under Circuit/System Testing .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.