SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 797 (LIGHTING SYSTEM)REPAIR INSTRUCTIONSTAIL LAMP REPLACEMENTINSTALLATION PROCEDURE
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2

Installation Procedure

2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Installation Procedure
WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Tail Lamp Bulb Assembly
    GM1115833Courtesy of GENERAL MOTORS CORP.
  1. Install the tail lamp bulb assembly into the tail lamp housing.
  2. Connect the tail lamp housing electrical connector.
    3. Fig 2: View Of Tail Lamp Assembly & Backup, Sidemarker, Stop, Turn Signal Bulb
    GM932887Courtesy of GENERAL MOTORS CORP.
  3. Align the tail lamp housing with the vehicle.
    4. NOTE: Refer to Fastener Notice .
  4. Install the tail lamp screws to the tail lamp.

    Tighten:  Tighten the tail lamp screw to 2.5 N.m (22 lb in).

  5. Close the rear compartment.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.