SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 727 (POWER STEERING SYSTEM)REPAIR INSTRUCTIONSPOWER STEERING PUMP BRACKET REPLACEMENTREMOVAL PROCEDURE
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2

Removal Procedure

2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Removal Procedure
WARNING: This page is about a different car, the 2006 GMC Sierra, 2006 GMC Cab & Chassis Sierra, 2006 Chevrolet Silverado, and 2006 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the power steering pump from the bracket (3). Refer to Power Steering Pump Replacement (4.3L) , Power Steering Pump Replacement (4.8L, 5.3L and 6.0L) , Power Steering Pump Replacement (8.1L) , Power Steering Pump Replacement (6.6L Diesel)  or Power Steering Pump Replacement (5.3L w/RPO HP2) .
    2. Fig 1: Removing Positive Battery Junction Block Bracket From Pump Bracket
    GM1237043Courtesy of GENERAL MOTORS CORP.
  2. Remove the positive battery junction block bracket retaining bolts (2) from the power steering pump bracket.
  3. Remove the bolts retaining the power steering pump bracket (3) to the engine.
    Fig 2: Removing Power Steering Pump Bracket
    GM1202281Courtesy of GENERAL MOTORS CORP.
  4. Remove the power steering pump bracket from the vehicle.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.