SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 727 (POWER STEERING SYSTEM)REPAIR INSTRUCTIONSCHECKING AND ADDING POWER STEERING FLUID (WITH HYDROBOOST)
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2

Checking and Adding Power Steering Fluid (With Hydroboost)

2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Checking and Adding Power Steering Fluid (With Hydroboost)
WARNING: This page is about a different car, the 2006 GMC Sierra, 2006 GMC Cab & Chassis Sierra, 2006 Chevrolet Silverado, and 2006 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: When adding fluid or making a complete fluid change, always use the proper power steering fluid. Failure to use the proper fluid will cause hose and seal damage and fluid leaks.
  1. If the power steering system has been serviced, bleed the power steering system to remove any trapped air from the system. Refer to Bleeding the Power Steering System .
    2. IMPORTANT: The oil level will appear falsely high if the hydro-boost accumulator is not fully charged. Do not apply the brake pedal with the engine off, this will discharge the hydro-boost accumulator.
  2. Fully charge the hydro-boost accumulator using the following procedure:
    1. Start the engine.
    2. Firmly apply the brake pedal 2 to 3 times.
    3. Turn the engine Off.
    3. IMPORTANT: The Add and Cold Full marks on the capstick are calculated for oil at ambient temperature. If the oil is hot, the oil level may appear slightly high.
  3. Clean the area surrounding the reservoir cap.
  4. Remove the reservoir cap.
    5. IMPORTANT: The ideal oil level is between the Add and the Full Cold marks. Since overfilling is just as undesirable as underfilling, there is no reason to full all the way up to the Full Cold mark.
  5. Inspect the power steering pump fluid level at regular intervals.

    Add fluid when required. Refer to Fluid and Lubricant Recommendations in Maintenance and Lubrication.

  6. If the fluid level is low, add power steering fluid to the proper level.
  7. Install the reservoir cap.
  8. When checking the fluid level after servicing the steering system, bleed the air from the system. Refer to Bleeding the Power Steering System .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.