Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 727 (POWER STEERING SYSTEM)COMPONENT LOCATORPOWER STEERING GEAR DISASSEMBLED VIEW (670 GEAR)
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2
Power Steering Gear Disassembled View (670 Gear)
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Power Steering Gear Disassembled View (670 Gear)
WARNING: This page is about a different car, the 2006 GMC Sierra, 2006 GMC Cab & Chassis Sierra, 2006 Chevrolet Silverado, and 2006 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Callouts For Fig 1
| Callout | Component Name |
|---|---|
| 1 | Hexagon Bolt |
| 2 | Lash Adjuster Nut |
| 3 | Pitman Shaft and Cover Assembly |
| 4 | O-Ring Seal |
| 5 | Steering Gear Housing Assembly |
| 6 | O-Ring Seal |
| 7 | O-ring Seal |
| 8 | Stub Shaft Housing (680 Gear) |
| 9 | Hexagon Bolt |
| 10 | Stub Shaft Housing (670 Gear) |
| 11 | Hexagon Bolt |
| 12 | Needle Bearing Assembly |
| 13 | Pitman Shaft Seal |
| 14 | Backup Washer |
| 15 | Retaining Ring |
| 16 | Dust Seal |
| 17 | Pitman Shaft Boot |
| 18 | Pitman Arm Assembly |
| 19 | Lock Washer |
| 20 | Pitman Arm Nut |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.