SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 697 (WIPER SYSTEM & WASHER SYSTEM)COMPONENT LOCATORWIPER/WASHER SYSTEM CONNECTOR END VIEWS
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2

Wiper/Washer System Connector End Views

2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Wiper/Washer System Connector End Views
WARNING: This page is about a different car, the 2006 GMC Sierra and 2006 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Washer Fluid Level Switch

GM655692Courtesy of GENERAL MOTORS CORP.
Connector Part Information
  • 12162195
  • 2-Way F Metri-Pack 150.2 Series, Sealed (BK)
Pin Wire Color Circuit No. Function
A BK/WH 174 Low Washer Fluid Indicator Signal
B BK 150 Ground
Windshield Washer Fluid Pump

GM635009Courtesy of GENERAL MOTORS CORP.
Connector Part Information
  • 12052641
  • 2-Way F Metri-Pack 150 Series (BK)
Pin Wire Color Circuit No. Function
A RD 228 Windshield Washer Pump Control
B BK 150 Ground
Windshield Wiper Motor Module

GM812593Courtesy of GENERAL MOTORS CORP.
Connector Part Information
  • 12186347
  • 6-Way F Metri-Pack 150 Series (GY)
Pin Wire Color Circuit No. Function
A BK 1050 Ground
B YE 143 Accessory Voltage
C D-BU 477 Windshield Wiper Switch High Signal
D PK 94 Windshield Wiper Switch Signal
E OG 2268 Windshield Washer Relay Control
F GY 478 Windshield Wiper Switch Supply Voltage
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.