SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 678 (ENGINE CONTROLS - 4.3L - INTRODUCTION (2 OF 2))COMPONENT LOCATORPOWERTRAIN CONTROL MODULE (PCM) CONNECTOR END VIEWSPOWERTRAIN CONTROL MODULE (PCM) - C2
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2

Powertrain Control Module (PCM) - C2

2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Powertrain Control Module (PCM) - C2
WARNING: This page is about a different car, the 2006 GMC Sierra and 2006 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Powertrain Control Module (PCM) - C2

GM73173Courtesy of GENERAL MOTORS CORP.
Connector Part Information 
  • OEM: 12191110
  • Service: See Catalog
  • Description: 80-Way F Micro-Pack 100 Series Sealed (GN)
Pin  Wire Color  Circuit No.  Function 
1 BK/WH 451 Ground
2 BN 418 TCC PWM Solenoid Valve Control (A/T)
3-5 - - Not Used
6 RD/BK 1228 PC Solenoid Valve High Control (A/T)
7 - - Not Used
8 L-BU/WH 1229 PC Solenoid Valve Low Control (A/T)
9 D-GN/WH 465 Fuel Pump Relay Control
10 WH 121 Engine Speed Signal
11-12 - - Not Used
13 L-BU/BK 396 Cruise Control Engaged Signal
14 RD/BK 380 A/C Refrigerant Pressure Sensor Signal
15 PU 5428 Generator Regulator Control
16 GY/BK 1694 4WD Low Signal
17 - - Not Used
18 D-GN 1433 Clutch Start Switch Signal (M/T)
19 BK/WH 1695 Axle Switch Signal
20 L-GN/BK 822 VSS Low Signal
21 PU/WH 821 VSS High Signal
22-23 - - Not Used
24 D-BU 417 TP Sensor Signal
25 TN 472 IAT Sensor Signal
26 WH 423 IC Timing Control
27-30 - - Not Used
31 YE 492 MAF Sensor Signal
32 L-GN 432 MAP Sensor Signal
33 D-BU 473 High Speed Cooling Fan Relay Control
34 D-GN/WH 428 EVAP Canister Purge Solenoid Control
35-38 - - Not Used
39 RD 631 12-Volt Reference
40 BK/WH 451 Ground
41 - - Not Used
42 TN/BK 422 TCC Solenoid Valve Control (A/T)
43 D-GN/WH 459 A/C Compressor Clutch Relay Control
44 - - Not Used
45 WH 1310 EVAP Canister Vent Solenoid Control
46 BN/WH 419 MIL Control
47 YE/BK 1223 2-3 Shift Solenoid Valve Control (A/T)
48 L-GN 1222 1-2 Shift Solenoid Valve Control (A/T)
49 YE/BK 1827 Vehicle Speed Signal
50 D-GN/WH 817 Vehicle Speed Signal
51 YE/BK 1227 TFT Sensor Signal
52 BN 2391 HO2S Heater Low Control - Bank 1 Sensor 2
53 RD/WH 3223 HO2S Heater Low Control - Bank 2 Sensor 2
54 PU/WH 1589 Fuel Level Sensor Signal
55-56 - - Not Used
57 BK 552 Low Reference
58 TN/WH 332 Oil Pressure Sensor Signal
59 PU 806 Crank Voltage
60-61 - - Not Used
62 GY 773 Transmission Range Switch Signal C (A/T)
63 PK 1224 Transmission Fluid Pressure Switch Signal A (A/T)
64 D-GN 890 Fuel Tank Pressure Sensor Signal
65-71 - - Not Used
72 BK/WH 3113 HO2S Heater Low Control - Bank 1 Sensor 1
73 - - Not Used
74 L-GN 3212 HO2S Heater Low Control - Bank 2 Sensor 1
75 GY 23 Generator Field Duty Cycle Signal
76 L-GN/WH 1749 IAC Coil B High Control
77 L-GN/BK 444 IAC Coil B Low Control
78 L-BU/BK 1748 IAC Coil A Low Control
79 L-BU/WH 1747 IAC Coil A High Control
80 BK 2751 Low Reference
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.