Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 669 (ENTERTAINMENT SYSTEMS)REPAIR INSTRUCTIONSRECEIVER REPLACEMENT - DIGITAL RADIOINSTALLATION PROCEDURE

2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2

Installation Procedure

2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Installation Procedure

WARNING: This page is about a different car, the 2006 GMC Sierra, 2006 GMC Cab & Chassis Sierra, 2006 Chevrolet Silverado, and 2006 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Connect the coaxial cable.
Connect the wire connector.

Fig 1: Connecting Digital Radio Receiver & Wire Connector
Courtesy of GENERAL MOTORS CORP.
Install the receiver and bracket assembly to the I/P.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the 2 retaining screws (1).
Tighten: Tighten the screws to 1.6 N.m (14 lb in).
Install the right side junction block to the I/P. Refer to Instrument Panel Electrical Center or Junction Block Replacement - Right in Wiring Systems.
Close the I/P compartment door.
Perform the setup procedure for the digital radio receiver. Refer to Digital Radio Receiver Setup .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.