Removal Procedure

2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Removal Procedure
WARNING: This page is about a different car, the 2006 GMC Sierra, 2006 GMC Cab & Chassis Sierra, 2006 Chevrolet Silverado, and 2006 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Fully open the door.
  2. Remove the door trim panel. Refer to Trim Panel Replacement - Side Front DoorΒ .
  3. Remove the water deflector. Refer to Water Deflector Replacement - Front DoorΒ .
  4. Fig 1: Removing Body-Side Check Link Pillar Bolt
    GM348484Courtesy of GENERAL MOTORS CORP.
  5. Remove the body-side check link pillar bolt.
  6. Remove the check strap plug.
  7. Remove the door-side check strap nuts.
  8. Pull the check strap from the inside of the door.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.