Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 664 (STATIONARY WINDOW SYSTEM)REPAIR INSTRUCTIONSREARVIEW MIRROR REPLACEMENTINSTALLATION PROCEDURE

2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2

Installation Procedure

2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Installation Procedure

WARNING: This page is about a different car, the 2006 GMC Sierra and 2006 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Position the center bottom of the mirror mount against the windshield at the top of the support button (1).

Fig 1: View Of Rearview Mirror Mounting Components
Courtesy of GENERAL MOTORS CORP.
Slide the base of the mirror onto the button.

NOTE: Refer to FASTENER NOTICE .

Make sure the mirror is firmly seated on the windshield button by pushing down on the base of the mirror.
Tighten: Tighten the screw (3) to 1.8 N.m (16 lb in) in order to secure the mirror base to the button.
Install the base trim cover.
Connect the electrical connector.

Fig 2: Connecting Rearview Mirror Electrical Connector
Courtesy of GENERAL MOTORS CORP.
Install the wire cover.
Reposition the mirror assembly.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.