SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 646 (DOOR SYSTEM, MIRROR SYSTEM & WINDOW SYSTEM)REPAIR INSTRUCTIONSSWITCH REPLACEMENT - DOOR LOCK AND SIDE WINDOW-DRIVERREMOVAL PROCEDURE
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2

Removal Procedure

2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Removal Procedure
WARNING: This page is about a different car, the 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, 2003 Chevrolet Silverado, and 2003 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front door trim panel. Refer to Trim Panel Replacement - Side Front Door   . 
  2. Disconnect the electrical connectors.
  3. Remove the screw that retains the switch panel bezel (1) from the front door panel.
    Fig 1: Removing Screw Retaining Switch Panel Bezel
    G01577841Courtesy of GENERAL MOTORS CORP.
  4. Remove the switch panel bezel from the door panel using a flat-bladed tool.
    Fig 2: Removing Switch Panel Bezel
    G01577842Courtesy of GENERAL MOTORS CORP.
  5. Using a wide plastic flat-bladed tool, release the retaining clips on both sides of the door module.
  6. Remove the door module from the switch panel bezel.
    Fig 3: Removing Door Module From Switch Panel Bezel
    G01577843Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.