SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 636 (INSTRUMENT PANEL, GAGES, AND CONSOLE)REPAIR INSTRUCTIONSCENTER CONSOLE END PANEL REPLACEMENTINSTALLATION PROCEDURE
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2

Installation Procedure

2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Installation Procedure
WARNING: This page is about a different car, the 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, 2003 Chevrolet Silverado, and 2003 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the power outlets to the end panel, if equipped. Refer to 12-Volt Power Supply Replacement   . 
  2. Install the rear seat audio control, if equipped. Refer to AUDIO CONTROL REPLACEMENT-REAR SEAT .
  3. Install the rear seat heater switch, if equipped. Refer to HEATED SEAT SWITCH REPLACEMENT-REAR .
  4. Connect all electrical connectors.
  5. Install the end panel to the console.
    NOTE: Refer to FASTENER NOTICE .
  6. Install the 2 top retaining screws.

    Tighten 

    Tighten the screws to 1.6 N.m (14 lb in).

    Fig 1: Installing Top Retaining Screws
    G01579506Courtesy of GENERAL MOTORS CORP.
  7. Install the 2 retaining screws.

    Tighten 

    Tighten the screws to 1.6 N.m (14 lb in).

  8. Install the rear cupholder to the end panel. Refer to Cupholder Replacement (Luxury)   or Cupholder Replacement (Non-Luxury)   or Cupholder Replacement (Rear)   or Cupholder Replacement (Pro)   . 
  9. Install the storage bin. Refer to Console Storage Bin Replacement (Expect Pro)   or Console Storage Bin Replacement (Pro)   . 
    Fig 2: Installing Retaining Screws
    G01579507Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.