Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DBβ LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 575 (ENGINE COOLING SYSTEM -- 5.7L)SPECIFICATIONSFASTENER TIGHTENING SPECIFICATIONS
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2
Fastener Tightening Specifications
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Fastener Tightening Specifications
WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
Fastener Tightening Specifications
| Application | Specification | |
|---|---|---|
| Metric | English | |
| Automatic Transmission Oil Cooler Line Fitting | 25 N.m | 18 lb ft |
| Coolant Air Bleed Bolt/Stud | 12 N.m | 106 lb in |
| Cooling Fan Motor Bolt | 6 N.m | 53 lb in |
| Engine Coolant Heater | 40 N.m | 30 lb ft |
| Engine Coolant Heater Cord Clip Bolt | 32 N.m | 24 lb ft |
| Fan Blade Nut | 6 N.m | 53 lb in |
| Radiator Baffle Bolt | 10 N.m | 89 lb in |
| Radiator Support Bolt | 8 N.m | 71 lb in |
| Radiator Surge Tank Nut | 10 N.m | 89 lb in |
| Stabilizer Shaft Bracket Bolt | 58 N.m | 43 lb ft |
| Water Pump Bolt (First Pass) | 15 N.m | 11 lb ft |
| Water Pump Bolt (Final Pass) | 30 N.m | 22 lb ft |
| Water Pump Inlet | 15 N.m | 11 lb ft |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.