SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 573 (AUTOMATIC TRANSMISSION - 4L60-E/4L65-E (INTRODUCTION, SERVICE & REPLACEMENT))REPAIR INSTRUCTIONSFLOOR SHIFT CONTROL BOOT REPLACEMENTREMOVAL PROCEDURE
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2

Removal Procedure

2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Removal Procedure
WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Floor Shift Control Knob & I/P Accessory Trim Plate
    GM71447Courtesy of GENERAL MOTORS CORP.
  1. Remove the console. Refer to Console Replacement in Instrument Panel, Gages and Console.
  2. Remove the I/P accessory trim plate. Refer to Trim Plate Replacement - Instrument Panel (I/P) Accessory in Instrument Panel, Gages and Console.
  3. Remove the floor shift control knob.
    1. Using a flat-bladed screwdriver, carefully pry the staple clip from the knob.
    2. Remove the knob from the floor shift control.
  4. Remove the floor shift control from the vehicle; to allow for boot replacement without possible damage to the boot retaining tabs. Refer to Floor Shift Control Replacement .
    5. Fig 2: Floor Shift Control Boot & Floor Shift Control
    GM190951Courtesy of GENERAL MOTORS CORP.
  5. Remove the floor shift control boot from the floor shift control.
    1. Carefully squeeze the front and side tabs or the rear and side tabs at the same time in order to release them.
    2. Carefully squeeze the remaining tab in order to release it.
    3. Release the snap lock retainer on the LH side of the boot.
    4. Move the boot to the left and release the shift indicator guide pin from the shift control lever.
    5. Disconnect the indicator lamp socket from the boot.
    6. Remove the boot from the shift control.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.