Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 46 (ENGINE CONTROL SYSTEM & COMPONENT TESTS - 4.3L)IDLE CONTROL SYSTEMIDLE AIR CONTROL SYSTEM DIAGNOSISTEST DESCRIPTION
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2
Test Description
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Test Description
WARNING: This page is about a different car, the 2003 GMC Savana and 2003 Chevrolet Chevy Express. However, it is still accessible from the selected car via links, so may be relevant.
The number below refers to step number in diagnostic procedure.
- 5 - This test will determine the ability of the PCM and IAC valve control circuits to control the IAC valve.
- 7 - This test will determine the ability of the PCM to provide the IAC control valve circuits with a ground. On a normally operating system, the test light should not flash while the IAC Counts are incrementing.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.