Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 406 (BODY FRONT END)REPAIR INSTRUCTIONSHOOD LATCH RELEASE CABLE REPLACEMENTINSTALLATION PROCEDURE

2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2

Installation Procedure

2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Insert and pull the cable toward the front of the vehicle through the hole in the cowl.

Fig 1: Cowl Hole & Cable

Courtesy of GENERAL MOTORS CORP.

Ensure that the grommet is seated.
Attach the cable end to the latch assembly.

Fig 2: Hood Release Cable & Latch

Courtesy of GENERAL MOTORS CORP.

Attach the cable to the retainer clips.

Fig 3: Hood Latch Cable Retainer Clips

Courtesy of GENERAL MOTORS CORP.

Attach the cable end to the cable handle.
Install the radiator air baffle and deflector. Refer to Radiator Air Baffle and Deflector Replacement - Upper in Engine Cooling.

NOTE: Refer to Fastener Notice in Cautions and Notices.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.