Installation Procedure

2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Installation Procedure
WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the bulb.
  2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the 2 retaining screws.

    Tighten:Β  Tighten the screws to 2 N.m (17 lb in).

  4. Fig 1: Courtesy Lamp Retaining Screws
    GM660890Courtesy of GENERAL MOTORS CORP.
  5. Connect the electrical wires.
  6. Install the exterior courtesy lamp into the rear view mirror pressing into place until fully seated.
  7. Fig 2: Exterior Courtesy Lamp Assembly
    GM660884Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.