SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 307 (ENTERTAINMENT SYSTEM)REPAIR INSTRUCTIONSRECEIVER REPLACEMENT - DIGITAL RADIOREMOVAL PROCEDURE
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2

Removal Procedure

2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Removal Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 Chevrolet Tahoe, 2003 Chevrolet Suburban, and 2003 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Important:  Do NOT swap digital radio receivers between vehicles. Swapping digital receivers between vehicles will activate the digital radio Theftlock®, and "XM Theftlock®" will display.

  1. Remove the right side junction block from the I/P.

    Do not disconnect the electrical connectors.

  2. Lower the I/P compartment door to the full open position.
  3. From the junction block opening, remove the two retaining screws.
  4. Pull the receiver and bracket assembly from the I/P compartment opening.
  5. Disconnect the wire connector (1).
    6. Fig 1: Removing Receiver & Bracket Assembly From I/P
    G01457836Courtesy of GENERAL MOTORS CORP.
  6. Disconnect the coaxial cables from the receiver.
  7. Remove the receiver and bracket assembly from the I/P.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.