Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 276 (POWER STEERING SYSTEM)STEERING GEAR AND LINKAGE ASSEMBLYOIL SEAL ASSEMBLY NOTE
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2
Oil Seal Assembly Note
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Oil Seal Assembly Note
WARNING: This page is about a different car, the 2004 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
- Apply ATF to the lip of a new oil seal.
- Install the SST (49 N032 319A) to the gear housing with the raised part facing up as shown in the figure.
- Set the stopper into the gear housing to hold the SSTs as shown in the figure.
- Install the oil seal using the SSTs (49 F032 303, 49 F032 304) and a press.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.