Removal Procedure

2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Removal Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 GMC Savana Special, 2003 GMC Savana Camper Special, 2003 GMC Savana, 2003 Chevrolet RV Cutaway, and 2003 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the radio and mounting bracket. Refer to Radio ReplacementΒ .
  2. Remove the engine cover. Refer to ENGINE COVER REPLACEMENT .
  3. Disconnect the antenna cable connector at the lower right of the instrument panel.
  4. Remove the antenna cable (1) from the retaining clips on the instrument panel carrier.
    Fig 1: Removing Antenna Cable From Retaining Clips
    G02422472Courtesy of GENERAL MOTORS CORP.
  5. Remove the antenna cable (1) from the vehicle.
    Fig 2: Removing Antenna Cable From Vehicle
    G02422473Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.