Installation Procedure

2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Installation Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 GMC Savana Special, 2003 GMC Savana Camper Special, 2003 GMC Savana, 2003 Chevrolet RV Cutaway, and 2003 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the antenna cable (1) to the vehicle.
    Fig 1: Installing Antenna Cable To Vehicle
    G02422474Courtesy of GENERAL MOTORS CORP.
  2. Install the cable (1) to the retaining clips on the instrument panel carrier.
  3. Connect the antenna cable connector at the lower right of the instrument panel.
  4. Install the engine cover. Refer to ENGINE COVER REPLACEMENT .
  5. Install the radio mounting bracket and radio. Refer to Radio ReplacementΒ .
    Fig 2: Installing Antenna Cable To Retaining Clips
    G02422475Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.