Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 242 (ENTERTAINMENT SYSTEM)REPAIR INSTRUCTIONSANTENNA CABLE REPLACEMENTINSTALLATION PROCEDURE
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2
Installation Procedure
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Installation Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 GMC Savana Special, 2003 GMC Savana Camper Special, 2003 GMC Savana, 2003 Chevrolet RV Cutaway, and 2003 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
- Install the fixed antenna cable/base (3).CAUTION: Refer to FASTENER NOTICE .
- Install the antenna cable/base mounting bolts (4).
Tighten
Tighten the antenna cable/base mounting bolts (4) to 11 N.m (97 lb in).
- Route the antenna base cable under the A/C case and through the hole in the firewall.
- Install the antenna cable grommet (5) through firewall and seat the grommet (5).
- Install the antenna collar (2).
- Connect the antenna base cable to the antenna extension cable.
- Install the passenger side hinge pillar trim. Refer to TRIM REPLACEMENT - HINGE PILLAR .
- Install the antenna mast (1). Refer to Fixed Antenna Mast Replacement .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.