SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 241 (LIGHTING SYSTEMS)REPAIR INSTRUCTIONSTAIL LAMP REPLACEMENTINSTALLATION PROCEDURE
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2

Installation Procedure

2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Installation Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 GMC Savana Special, 2003 GMC Savana Camper Special, 2003 GMC Savana, 2003 Chevrolet RV Cutaway, and 2003 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the bulbs into the sockets by turning the bulbs in a clockwise direction.
  2. Connect the bulb sockets into the tail lamp (3).
    CAUTION: Refer to FASTENER NOTICE .
  3. Install the tail lamp retaining nuts (2) to the upper quarter panel.

    Tighten 

    Tighten the nuts to 5 N.m (44 lb in).

  4. Install the upper quarter panel applique. Refer to TAIL LAMP, BACK BODY OPENING APPLIQUE REPLACEMENT - SIDE .
    Fig 1: Installing Tail Lamp
    G02422346Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.