SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2242 (WIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT CONNECTOR END VIEWS - ELECTRONIC COMPASS MODULE TO MEMORY SEAT MODULE (X4))COMPONENT CONNECTOR END VIEWSHEATED SEAT CONTROL MODULE - REAR X4 (KA6)
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2

Heated Seat Control Module - Rear X4 (KA6)

2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Heated Seat Control Module - Rear X4 (KA6)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
GM1664552Courtesy of
Connector Part Information
  • Harness Type: Left Rear Seat
  • OEM Connector: 31410-1200
  • Service Connector: 15126711
  • Description: 20-Way F (BK)
Terminal Part Information
  • Terminated Lead: 13575299
  • Release Tool: J-38125-215A
  • Diagnostic Test Probe: J-35616-64B (L-BU)
  • Terminal/Tray: SAIT-A03T-M064/14
  • Core/Insulation Crimp: P/P
Heated Seat Control Module - Rear X4 (KA6)

Pin Wire Circuit Function
1 - - Not Used
2 0.35 BK 1150 Ground
3-8 - - Not Used
9 0.35 L-BU 2299 Left Rear Heated Seat Sensor Signal
10-19 - - Not Used
20 0.35 OG 2300 Right Rear Heated Seat Sensor Signal
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.