SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2240 (WIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT CONNECTOR END VIEWS - A/C COMPRESSOR TO EBCM (JH6))COMPONENT CONNECTOR END VIEWSBLOWER MOTOR CONTROL MODULE X2
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2

Blower Motor Control Module X2

2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Blower Motor Control Module X2
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
GM1837860Courtesy of
Connector Part Information
  • Harness Type: HVAC
  • OEM Connector: 13520671
  • Service Connector: 88988512
  • Description: 6-Way F GT 150 6.3 Series (BK)
Terminal Part Information
  • Pin 3
  • Terminated Lead: 13575735
  • Release Tool: J-38125-553
  • Diagnostic Test Probe: J-35616-2A (GY)
  • Terminal/Tray: 12191812/19
  • Core/Insulation Crimp: E/C
  • Pins: 5, 6
  • Terminated Lead: 13575835
  • Release Tool: J-38125-11A
  • Diagnostic Test Probe: J-35616-42 (RD)
  • Terminal/Tray: 7116-4122-02/10
  • Core/Insulation Crimp: A/B
Blower Motor Control Module X2

Pin Wire Circuit Function
1-2 - - Not Used
3 0.35 PU/WH 754 Blower Motor Speed Control
4 - - Not Used
5 5 BK 1050 Ground
6 3 RD 542 Battery Positive Voltage
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.