SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2240 (WIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT CONNECTOR END VIEWS - A/C COMPRESSOR TO EBCM (JH6))COMPONENT CONNECTOR END VIEWSASSIST STEP CONTROL MODULE X2 (BRS)
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2

Assist Step Control Module X2 (BRS)

2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Assist Step Control Module X2 (BRS)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
GM2180214Courtesy of
Connector Part Information
  • Harness Type: Chassis
  • OEM Connector: 13530777
  • Service Connector: 13504588
  • Description: 12-Way F GT 150 Series, Sealed (BK)
Terminal Part Information
  • Terminated Lead: 13575354
  • Release Tool: J-38125-553
  • Diagnostic Test Probe: J-35616-2A (GY)
  • Terminal/Tray: 12191819/8
  • Core/Insulation Crimp: E/1
Assist Step Control Module X2 (BRS)

Pin Wire Circuit Function
A 0.5 PK 7468 10-Volt Reference
B 0.5 L-GN 7464 10-Volt Referencee
C 0.5 YE 7467 Running Board Motor Hall Sensor Left Signal
D 0.5 PU 7465 Running Board Motor Hall Sensor Right Signal
E 0.5 TN 7466 Low Reference
F 0.5 YE/BK 7463 Low Reference
G - - Not Used
H 0.5 D-GN 5060 Low Speed GMLAN Serial Data
J 0.5 D-GN 5060 Low Speed GMLAN Serial Data (UFT, except HP2)
K 0.5 TN/WH 7462 Running Board Disable Signal
L-M - - Not Used
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.