Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2184 (HYBRID/EV CONTROL SYSTEM)SPECIFICATIONSTEMPERATURE VERSUS RESISTANCE
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2
Temperature Versus Resistance
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Temperature Versus Resistance
WARNING: This page is about a different car, the 2012 GMC Yukon, 2012 Chevrolet Tahoe, and 2012 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
Drive Motor 1 and 2 Temperature Sensor
| °C | °F | OHMS (±10%) |
|---|---|---|
| Temperature vs Resistance Values (Approximate) | ||
| 230 | 446 | 106 |
| 220 | 428 | 128 |
| 210 | 410 | 154 |
| 200 | 392 | 187 |
| 190 | 374 | 228 |
| 180 | 356 | 281 |
| 170 | 338 | 349 |
| 160 | 320 | 436 |
| 150 | 302 | 550 |
| 140 | 284 | 701 |
| 130 | 266 | 903 |
| 120 | 248 | 1176 |
| 110 | 230 | 1550 |
| 100 | 212 | 2069 |
| 90 | 194 | 2799 |
| 80 | 176 | 3843 |
| 70 | 158 | 5359 |
| 60 | 140 | 7599 |
| 50 | 122 | 10, 970 |
| 40 | 104 | 16, 150 |
| 30 | 86 | 24, 270 |
| 20 | 68 | 37, 300 |
| 10 | 50 | 58, 750 |
| 0 | 32 | 94, 980 |
| -10 | 14 | 158, 000 |
| -20 | -4 | 271, 200 |
| -30 | -22 | 481, 000 |
| -40 | -40 | 884, 600 |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.