SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2179 (POWER STEERING SYSTEM)REPAIR INSTRUCTIONSPOWER STEERING FLUID COOLER REPLACEMENT (WITH HYDROBOOST)INSTALLATION PROCEDURE
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2

Installation Procedure

2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Installation Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Power Steering Cooler & Bolts
    GM686121Courtesy of GENERAL MOTORS COMPANY
  1. Install the power steering fluid cooler (1) to the vehicle.
    2. CAUTION:

    Refer to Fastener Caution .

  2. Install the power steering fluid cooler bolts (2).

    Tighten 

    Tighten the bolts to 9 N.m (80 lb in).

    3. Fig 2: View Of Power Steering Gear, Pump, Cooler Inlet Hose & Cooler Outlet Hose
    GM686126Courtesy of GENERAL MOTORS COMPANY
  3. Connect the power steering fluid cooler hose (4) to the power steering pump (1).
  4. Connect the power steering fluid cooler hose (3) to the steering gear (2).
  5. Clean any excess fluid from the vehicle and remove the drain pans.
  6. Install the radiator grille reinforcement support, if equipped. Refer to Radiator Grille Reinforcement Support Replacement .
  7. Install the fascia grille. Refer to Fascia Grille Replacement (Z71) , Fascia Grille Replacement (Escalade) , Fascia Grille Replacement (GMC Denali XL) , Fascia Grille Replacement (Suburban, Tahoe) , Fascia Grille Replacement (GMC Yukon Hybrid 2 Mode) , Fascia Grille Replacement (Yukon) .
  8. Fill and bleed the power steering system. Refer to Power Steering System Bleeding .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.