SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2154 (WIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT CONNECTOR END VIEWS - MEMORY SEAT MODULE (X5) TO YAW SENSOR)COMPONENT CONNECTOR END VIEWSVEHICLE COMMUNICATION INTERFACE MODULE (VCIM) X2 (UE1)
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2

Vehicle Communication Interface Module (VCIM) X2 (UE1)

2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Vehicle Communication Interface Module (VCIM) X2 (UE1)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
GM1471691Courtesy of
Connector Part Information
  • Harness Type: Instrument Panel (STZ or Y91)
  • Harness Type: Instrument Panel Extension (without STZ or Y91)
  • OEM Connector: 15431365
  • Service Connector: 88952886
  • Description: 12-Way F Micro-Pack 100A Series (NA)
Terminal Part Information
  • Terminated Lead: 13575548
  • Release Tool: J-38125-559
  • Diagnostic Test Probe: J-35616-16 (L-GN)
  • Terminal/Tray: 15445905/23
  • Core/Insulation Crimp: J/J
Vehicle Communication Interface Module (VCIM) X2 (UE1)

Pin Wire Circuit Function
1 0.35 D-BU 658 Cellular Telephone Voice Signal
2 0.35 L-BU/BK 659 Low Reference
3 0.5 TN/BK 2500 High Speed GMLAN Serial Data Bus+
4 0.5 TN 2501 High Speed GMLAN Serial Data Bus-
5-7 - - Not Used
8 0.5 BARE 1782 Drain Wire (HP2)
0.35 BARE 1782 Drain Wire (except HP2)
9 0.35 GY 655 Cellular Microphone Signal
10 0.5 BARE 514 Ground (HP2)
10 0.35 BARE 514 Ground (except HP2)
11-12 - - Not Used
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.