SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2153 (KEYLESS ENTRY SYSTEM AND REMOTE FUNCTIONS)REPAIR INSTRUCTIONSREMOTE CONTROL DOOR LOCK RECEIVER ANTENNA REPLACEMENT (ESCALADE)
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2

Remote Control Door Lock Receiver Antenna Replacement (Escalade)

2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Remote Control Door Lock Receiver Antenna Replacement (Escalade)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Remote Control Door Lock Receiver Antenna
GM2164138Courtesy of GENERAL MOTORS COMPANY
Remote Control Door Lock Receiver Antenna Replacement (Escalade)

Callout Component Name

Preliminary Procedures

  1. Disable roof rail SIR system. Refer to SIR Disabling and Enabling .
  2. Remove body side lock pillar garnish molding. Refer to Body Lock Pillar Garnish Molding Replacement (Standard Wheelbase) , Body Lock Pillar Garnish Molding Replacement (Avalanche/Escalade EXT) , Body Lock Pillar Garnish Molding Replacement (Extended Wheelbase) .
  3. Remove rear upper garnish molding. Refer to Rear Upper Garnish Molding Replacement (Avalanche/Escalade EXT) .
1 Remote Control Door Lock Receiver Antenna

Procedure

  1. Disconnect the antenna from the remote control door lock receiver.
  2. Note the routing of the antenna.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.