SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2148 (STEERING WHEEL AND STEERING COLUMN)REPAIR INSTRUCTIONSTURN SIGNAL MULTIFUNCTION SWITCH REPLACEMENT
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2

Turn Signal Multifunction Switch Replacement

2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Turn Signal Multifunction Switch Replacement
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Multifunction Turn Signal Switch & Screws
GM1701070Courtesy of GENERAL MOTORS COMPANY
Turn Signal Multifunction Switch Replacement

Callout Component Name
WARNING:

Refer to SIR Warning .

Preliminary Procedure

  1. Remove the steering wheel. Refer to Steering Wheel Replacement .
  2. Remove the steering column shroud. Refer to Steering Column Shroud Replacement (With Electronic Tilt Steering) , Steering Column Shroud Replacement (Without Electronic Tilt Steering) .
1 Turn Signal Multifunction Switch Bolt (Qty: 2)
CAUTION:

Refer to Fastener Caution .


Tighten 
3 (27 lb in)
2 Turn Signal Multifunction Switch
Procedure 
Disconnect any electrical connectors as needed.
NOTE:

The wiper and washer switches are integral to the turn signal multifunction switch.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.