Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2148 (STEERING WHEEL AND STEERING COLUMN)DIAGNOSTIC INFORMATION AND PROCEDURESDIAGNOSTIC CODE INDEX
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2
Diagnostic Code Index
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Diagnostic Code Index
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC CODE INDEX
| DTC | Description |
|---|---|
| DTC B2850, B2855, B2870, or B2875 | DTC B2870 01 Tilt Up Switch Circuit Short to Battery DTC B2875 01 Tilt Down Switch Circuit Short to Battery |
| DTC B2860 or B2880 | DTC B2880 01 Tilt Position Sensor Circuit Short to Battery DTC B2880 06 Tilt Position Sensor Circuit Short to Ground or Open DTC B2880 5A Tilt Position Sensor Circuit Plausibility Failure DTC B2880 61 Tilt Position Sensor Actuator Stuck |
| DTC B2890 | DTC B2890 4B Tilt and Telescope Motor Circuit Calibration Not Learned |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.