SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 214 (FRONT SUSPENSION SYSTEM)REPAIR INSTRUCTIONSSHOCK ABSORBER REPLACEMENT (4WD)INSTALLATION PROCEDURE
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2

Installation Procedure

2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Installation Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 GMC Savana Special, 2003 GMC Savana Camper Special, 2003 GMC Savana, 2003 Chevrolet RV Cutaway, and 2003 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the shock absorber. Insert the stem through the hole in the shock tower.
  2. Align the shock absorber with the mounting holes in the lower control arm.
    NOTE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems
  3. Install the shock absorber lower mounting bolt and nut.

    Tighten 

    Tighten the nut to 80 N.m (59 ft lbs).

  4. Install the shock absorber upper retaining nut and bushing.

    Tighten 

    Tighten the nut to 20 N.m (15 ft lbs).

  5. Remove the safety stands.
  6. Lower the vehicle.
  7. Dispose of the shock absorber. Refer to Shock Absorber Disposal .
    Fig 1: Installing the shock absorber upper retaining nut and bushing
    G01269744Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.