Liftgate Trim Panel Replacement

2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Liftgate Trim Panel Replacement
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Liftgate Trim Finish Panel Assembly & Components
GM1671018Courtesy of GENERAL MOTORS COMPANY
Liftgate Trim Panel Replacement

Callout Component Name
Preliminary Procedure 
Remove liftgate window upper garnish molding. Refer to Liftgate Garnish Molding Replacement .
1 Liftgate Trim Finish Panel Screw (Qty: 4)
CAUTION:

Refer to Fastener Caution .


Tighten 
2 N.m (18 lb in)
2 Liftgate Trim Finish Panel Assembly
  1. Pull outward to disengage retainers and clips.
  2. Disconnect electrical connector.
3 Liftgate Trim Finish Panel Retainer (Qty: 12)
4 Liftgate Trim Finish Panel Clip (Qty: 5)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.