SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2132 (OBJECT DETECTION SYSTEM - PARK ASSIST SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESPARK ASSIST BLOCKED MESSAGE ONCIRCUIT/SYSTEM VERIFICATION
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2

Circuit/System Verification

2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Circuit/System Verification
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

After the detected cause has been addressed the vehicle must be driven at speed greater than 40 km/h (25 mph).

  1. Verify the "PARK ASST BLOCKED SEE OWNERS MANUAL" or "PARK ASSIST BLOCKED SEE OWNERS MANUAL" message is not ON for one of the reasons listed in table above. Perform the following steps:
    • If the message is ON and "operating as designed" column is "Yes" per table above

      The park assist system is functioning correctly and requires no repairs, correct the condition causing the message to be ON and explain normal operation to the customer.

    • If the message is ON and "operating as designed" column is "No" per table above
  2. Perform appropriate action listed in the Corrective Action column per the table above.
    • If the message is not ON 
  3. All OK.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.