Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2036 (POWER STEERING SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESDTC C056ECIRCUIT/SYSTEM VERIFICATION
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2
Circuit/System Verification
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Circuit/System Verification
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Verify DTC C056E 42 is not set.
- If DTC C056E 42 is set, perform the PSCM programming and setup procedures. If DTC C056E 42 resets, replace the PSCM.
- Verify DTC C056E 4B is not set.
- If DTC C056E 4B is set, perform the steering position/torque sensor calibration. If DTC C056E 4B resets, replace the PSCM.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.