Radiator Inlet Hose Replacement (HP2)

2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Radiator Inlet Hose Replacement (HP2)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Radiator Inlet Hose (HP2)
GM1966736Courtesy of GENERAL MOTORS CORP.
Radiator Inlet Hose Replacement (HP2)

Callout Component Name

Preliminary Procedures

  1. Drain the cooling system. Refer to Cooling System Draining and Filling (Static Fill)Β .
  2. If necessary, remove the air cleaner resonator duct. Refer to Air Cleaner Resonator Outlet Duct Replacement .
1 Radiator Inlet Hose
  • Remove the radiator vent hose from the radiator inlet hose clips.
  • Using J 38185 reposition the radiator inlet hose clamps.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.