SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2012 (POWER DOOR LOCK SYSTEM AND RELEASE SYSTEMS)REPAIR INSTRUCTIONSFRONT SIDE DOOR LOCK REPLACEMENT
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2

Front Side Door Lock Replacement

2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Front Side Door Lock Replacement
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Front Side Door Lock
GM1673309Courtesy of GENERAL MOTORS CORP.
Front Side Door Lock Replacement

Callout Component Name

Preliminary Procedures

  1. Position the door window as needed for service.
  2. Remove the door trim panel. Refer to Front Side Door Trim Panel Replacement .
  3. Remove the water deflector. Refer to Front Side Door Water Deflector Replacement .
1 Inside Door Handle Cable Retainer Clip
2 Front Side Door Lock Screw (Qty: 3)
CAUTION:

Refer to Fastener Caution .

  1. Release the door lock cylinder rod.
  2. Release the outside door handle rod from the door lock clip.
  3. The mandatory sequence is 3, 1, 2.

Tighten 
10 N.m (89 lb in)
3 Front Side Door Lock
  1. Disconnect the electrical plug.
  2. Transfer all parts to the new lock.
  3. It may be necessary to reprogrammed the door lock module after replacing the lock. Refer to Control Module References .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.