Endgate Latch Replacement

2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Endgate Latch Replacement
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Endgate Latch Assembly And Bolt
GM1709363Courtesy of GENERAL MOTORS CORP.
Endgate Latch Replacement

Callout Component Name
1 Endgate Latch Rod
TIP:Β  Disconnect the latch rod from the latch handle.
2 Endgate Latch Bolt (Qty: 2)
CAUTION:

Refer to Fastener Caution .


TightenΒ 
25 N.m (18 lb ft)
3 Endgate Latch Assembly Actuator Rod Clip
4 Endgate Latch Assembly
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.