Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2011 (FIXED AND MOVEABLE WINDOWS)REPAIR INSTRUCTIONSFRONT SIDE DOOR WINDOW REPLACEMENT

2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2

Front Side Door Window Replacement

2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Front Side Door Window Replacement

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Front Side Door Window

Courtesy of GENERAL MOTORS CORP.

Front Side Door Window Replacement

Callout

Component Name

Preliminary Procedures

Position the door window as needed for service.
Remove the front door trim panel. Refer to Front Side Door Trim Panel Replacement .
Remove the front door water deflector. Refer to Front Side Door Water Deflector Replacement .
Remove the front side door inner belt sealing strip. Refer to Front Side Door Window Belt Inner Sealing Strip Replacement .

Front Door Window Bolt (Qty: 2)

CAUTION:

Refer to Fastener Caution .

Procedure
Loosen the 2 bolts that attach the window to the window regulator.
Tighten
10 N.m (89 lb in)

Front Door Window
TIP: The window must be tilted downward into the door to remove it.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.