Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2011 (FIXED AND MOVEABLE WINDOWS)DIAGNOSTIC INFORMATION AND PROCEDURESDTC B3205CIRCUIT/SYSTEM TESTING
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2
Circuit/System Testing
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Circuit/System Testing
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, disconnect the harness connector at the appropriate driver or passenger window motor.
- Connect a test lamp between the control circuit terminal A and control circuit terminal B.
- Ignition ON, command the window UP and DOWN by using the door lock/window switch. The test lamp should turn ON when commanding the UP and DOWN states.
- If the test lamp is always OFF during either of the commands, test either control circuit for a short to ground or open/high resistance. If the circuits test normal, replace the door lock/window switch.
- If the test lamp is always ON, test either control circuit for a short to voltage. If the circuits test normal, replace the door lock/window switch.
- If all circuits test normal, test or replace the window motor.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.