Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2006 (STEERING WHEEL AND STEERING COLUMN)SPECIFICATIONSFASTENER TIGHTENING SPECIFICATIONS
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2
Fastener Tightening Specifications
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Fastener Tightening Specifications
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fastener Tightening Specifications
| Application | Specification | |
|---|---|---|
| Metric | English | |
| Automatic Transmission Control Bolt | 10 N.m | 89 lb in |
| Lower Steering Column Shroud Bolt | 3 N.m | 27 lb in |
| Shift Lever Bolt | 20 N.m | 15 lb ft |
| Steering Column Bracket Screw | 6 N.m | 53 lb in |
| Steering Column Bolt | 27 N.m | 20 lb ft |
| Steering Column Nut | 27 N.m | 20 lb ft |
| Steering Column Seal Nut | 3 N.m | 27 lb in |
| Steering Shaft Coupling Bolt (at the Upper Intermediate Shaft) | 50 N.m | 37 lb ft |
| Steering Shaft Coupling Bolt (at the Steering Gear) | 47 N.m | 35 lb ft |
| Steering Shaft Coupling Nut (at the Steering Column) | 62 N.m | 46 lb ft |
| Steering Wheel Heat Module Screw | 2 N.m | 18 lb in |
| Steering Wheel Lower Cover Bolt | 1 N.m | 9 lb in |
| Steering Wheel Nut | 41 N.m | 30 lb ft |
| Tilt Motor Bracket Bolt | 2 N.m | 18 lb in |
| Turn Signal Multifunction Switch Bolt | 3 N.m | 27 lb in |
| Upper Steering Column Shroud Bolt | 2 N.m | 18 lb in |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.