SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2000 (CELLULAR SYSTEM, ENTERTAINMENT SYSTEM, AND NAVIGATION SYSTEM)REPAIR INSTRUCTIONSRADIO SPEAKER AMPLIFIER REPLACEMENT (CADILLAC)
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2

Radio Speaker Amplifier Replacement (Cadillac)

2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Radio Speaker Amplifier Replacement (Cadillac)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Radio Speaker Amplifier Assembly And Components
GM1704287Courtesy of GENERAL MOTORS CORP.
Radio Speaker Amplifier Replacement (Cadillac)

Callout Component Name

Preliminary Procedures

  1. Remove the floor console bezel. Refer to Floor Console Bezel Replacement (Except Cadillac) , Floor Console Bezel Replacement (Cadillac) .
  2. Remove the front floor console side trim front panel - Left. Refer to Front Floor Console Side Trim Front Panel Replacement - Left Side (Cadillac) .
  3. Remove the front floor console side trim front panel - Right. Refer to Front Floor Console Side Trim Front Panel Replacement - Right Side (Cadillac) .
1 Front Floor Console Bolt (Qty: 2)
CAUTION:

Refer to Fastener Caution .


Tighten 
2 N.m (18 lb in)
2 Front Floor Console Rear Screw (Qty: 2)
TIP:  Open the rear cupholder to access the screws.
Tighten 
2 N.m (18 lb in)
3 Front Floor Console Lower Screw (Qty: 4)

Procedure

  1. Move the seats forward or rearward to access the screws as needed.
  2. Rotate the upper portion of the console assembly rearward to access the amplifier.

Tighten 
9 N.m (80 lb in)
4 Amplifier Screw (Qty: 4)
Tighten 
9 N.m (80 lb in)
5 Radio Speaker Amplifier Assembly

Procedure

  1. Disconnect the electrical connectors.
  2. For programming and set up, refer to Control Module References .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.