High Mount Stop Lamp Replacement (Avalanche)

2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION High Mount Stop Lamp Replacement (Avalanche)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: High Mount Stop Lamp Assembly, Screws And Clips
GM1823410Courtesy of GENERAL MOTORS CORP.
High Mount Stop Lamp Replacement (Avalanche)

Callout Component Name
Preliminary Procedure 
Remove the center cargo bridge panel. Refer to Cargo Box Bridge Cross Bar Replacement (Escalade EXT) , Cargo Box Bridge Cross Bar Replacement (Avalanche) .
1 High Mounted Stop Lamp Attachment Clip (Qty: 2)
2 High Mount Stop Lamp Assembly Screw
CAUTION:

Refer to Fastener Caution .


Tighten 
2 N.m (18 lb in)
3 High Mount Stop Lamp Assembly
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.