SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1991 (LIGHTING SYSTEM)REPAIR INSTRUCTIONSHEADLAMP REPLACEMENT (ESCALADE PLATINUM)
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2

Headlamp Replacement (Escalade PLATINUM)

2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Headlamp Replacement (Escalade PLATINUM)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Headlamp Assembly And Components (Escalade PLATINUM)
GM2039272Courtesy of GENERAL MOTORS CORP.
Headlamp Replacement (Escalade PLATINUM)

Callout Component Name

Preliminary Procedures

  1. Remove the 2 forward wheelhouse liner screws.
  2. Remove the 3 washer container push pins.
  3. Open the hood.
  4. Through the wheelhouse opening, loosen the lower headlamp bolt (1) but do not remove.
  5. Remove the 2 upper headlamp bolts.
  6. Grasp the headlamp at the upper inboard and lower outboard side and pull the headlamp forward to disengage from the lower radiator support bracket.
  7. Pull the outboard side of the headlamp forward until the locating pins disengage from the radiator support.
  8. Disconnect the forward lamp electrical harness connector from the headlamp control module.
1 Headlamp Lower Screw
CAUTION:

Refer to Fastener Caution .


Tighten 
6 N.m (53 lb in)
2 Headlamp Screw (Qty: 2)
Tighten 
6 N.m (53 lb in)
3 Headlamp Support Bracket
TIP:  Pull to release the headlamp tab from the bracket on the radiator support.
4 Forward Lamp Harness Electrical Connector
5 Headlamp Assembly
TIP:  The headlamp assembly is light emitting diode (LED). The only part serviceable is the ELC module, transfer the module as needed upon headlamp replacement.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.