SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1940 (WIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT CONNECTOR END VIEWS - F-H)COMPONENT CONNECTOR END VIEWS - F THROUGH HHEATED SEAT CONTROL MODULE X2 (SPO HEATED SEATS)
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2

Heated Seat Control Module X2 (SPO Heated Seats)

2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Heated Seat Control Module X2 (SPO Heated Seats)
WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Heated Seat Control Module X2 (SPO Heated Seats)
GM1653389Courtesy of GENERAL MOTORS CORP.
Heated Seat Control Module X2 (SPO Heated Seats)

Pin Wire Circuit Function
1 2 RD/WH 2340 Battery Positive Voltage
2 2 BK 1050 Ground
3-4 - - Not Used
5 0.35 D-GN 2426 Low Reference
6 0.35 YE 2080 Low Reference
7 0.35 TN 2482 Low Reference
8 0.35 L-BU 5476 Low Reference
Connector Part Information 
  • Harness: Heated Driver Seat
  • OEM: 6098-4713
  • Service: 88988652
  • Description: 8-Way F 2.8 Series (BK)
Terminal Part Information 
  • Pins: 1-2
  • Terminal/Tray: 8100-4445/22
  • Core/Insulation Crimp: 4/4
  • Release Tool/Test Probe: 15315247/J-35616-35 (VT)
  • Pins: 5-8
  • Terminal/Tray: 8100-4443/22
  • Core/Insulation Crimp: E/A
  • Release Tool/Test Probe: 15315247/J-35616-35 (VT)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.