Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1889 (ENGINE CONTROL SYSTEM & FUEL SYSTEM - 6.6L (LMM) - DTC P0016 TO DTC P02E7)DTC P003ACIRCUIT/SYSTEM VERIFICATION
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2
Circuit/System Verification
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Circuit/System Verification
WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Verify that DTCs P0047, P0048, P0652, P0653, P0698, P0699, P2564, or P2565 are not set.
- If any of the DTCs are set, refer to Diagnostic Trouble Code (DTC) List - Vehicle .
- Engine running, increase the engine speed to 1,500 RPM and maintain. Command the TC Vane Pos. Ctrl. Solenoid ON and OFF with a scan tool. Observe the Vane Position Sensor parameter. The TC Vane Position Sensor parameter should increase to 95-99 percent and decrease to near 0 percent when commanded ON and OFF.
- Engine running, observe the TC Vane position Sensor and the Desired TC Vane Position parameters with a scan tool. Slowly increase the engine speed from idle to 2,500 RPM, and slowly return the engine to idle speed. The TC Vane Position Sensor parameter should remain near or equal to the Desired TC Vane Position parameter throughout the engine speed range.
- Engine running, observe the TC Vane Position Sensor and the Desired TC Vane Position parameters while increasing the TC vane position in 5 percent increments from 0-100 percent with a scan tool. The parameters should remain within 2 percent of each other during the entire range.
- Operate the vehicle within the Conditions for Running the DTC to verify that the DTC does not reset. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.